Exotherm 24 x 48 x 3 No Seal HDPE Epoxy Reusable Form Swag Mold release is not needed

Mold release is not needed but will not hurt if used

Mirka Gold 6" sandpaper 6 holes 220 grit

ALWAYS TEST BEFORE FULL APPLICATION

The hair pin legs have a wave look to them which stands out from most standard hair pin legs

Exotherm 24 x 48 x 3 No Seal HDPE Epoxy Reusable Form Swag Mold release is not needed24 x 48 x 3 NO SEAL FORMThese forms have welded sides that dont require any sealant or tuck tape. Your project is easily removed by tapping the sides and back with a mallet. Once removed, you can start another immediatelyPlease use rubber mallet to tap your cured project out of the form by gently hitting the inside of the sides and flipping over and hitting the bottom. Using excessive force inside on the sides and using a metal hammer will void any