Buna-N Synthetic Rubber Buna-N Rubber:15 lb. Roll PC System Requirements: Windows operating

PC System Requirements:  Windows operating system (32-bit or 64-bit)

A6 - 4 1/8" x 5 7/8"

The suggestions in the table below are a good starting point as you begin test engraving this material

ACE 7 -- 5" x 7" -- Plastic Lid

Buna-N Synthetic Rubber Buna-N Rubber:15 lb. Roll PC System Requirements: Windows operatingBuna N is a black, synthetic rubber used to form stamp or printing dies that will be used with alcohol, acid or oil based inks. . 090" . 100" thick. Pre treated with Mica powder and supplied on a film backing. Use with our Release Paper to prevent sticking to your press. Higher durometer than regular stamp gum so the molded die is harder. Vulcanizes in approximately 10 minutes at 300 degrees F. Sold in 10" x 18" sheets, 15 lb. rolls or 50 lb. rolls.